CRC Travel Limiters

December 24th, 2009 crc2 Comments off

Fits Mustang/4th Gen F-Body or any vehicle with shock towers.

CRC Limiters3A

Makes adjusting your front end travel a snap. Can be mounted on the top or the front or back side of shock tower. Comes with limiters as shown, 2 chain connectors(not shown), anchor tab for lower a-arm(if needed).

Some welding is required. $115.00

CRC Limiters4A

Categories: CRC Products Tags:

SBF 302 Alternator Bracket Kit

November 29th, 2009 crc2 Comments off

Fits 302 and uses a GM alternator, factory reverse rotation water pump and a stock tensioner pulley.
Machined out of 6061 aluminum. $100.00

CRC SBF Alt Brkt

Categories: CRC Products Tags:

CRC Tool Tray-UPDATED!! 11/29/2009

November 29th, 2009 crc2 Comments off

Now available with bottom tray that can be used for storage and transporting the tray safely!!

CIMG1219If you’re like me, you despise working out of a carb tool tray. They seemed to get overloaded then get top heavy…well you know the rest. The FI guys have no options other than laying tools across the engine or on a fender cover but now they do, the CRC Tool Tray.

Made out of .063 6061 aluminum they measure 10″ long and 22″ wide (custom lengths are available). The stands and supports are 6061 also.

In the near future attachments will be offered for things like AN wrenches, push rods, lifters, springs, etc…
$125.00

Right now the mounting system is designed for a 79-93 Mustang stock core support but these trays can be easily adapted to other vehicles. Just let me know what it is you need and we can get you fixed up.

CRC Tool Tray 112909

CRC Tool Tray Bottom

As for it’s capacity, it held up with no problems with a 45lb Hypertherm 45 Plasma Cutter and with the new updated support rods the maximum capacity has increased.

CRC Tool Tray 4

CRC Tool Tray 5

CRC Tool Tray 6

Categories: CRC Products Tags:

CRC Fuel Door Charging Plates for 79-93 Mustang

November 4th, 2009 crc2 Comments off

Make charging your battery simple between rounds. If you run a Mustang with a struted wing you already know what a pain it is to charge your battery. The CRC Charging Plate fits inside your factory fuel door and uses a quick disconnect charging plug. The kit comes with 2 charging plugs and stainless hardware to make installation a breeze. No modifications are needed other than your filler neck be removed.

You can get these with just the charging QD’s or for just a few dollars more you can get one with a 2 1/16 or 2 5/8 gauge hole. The necessary bracket is supplied for the plates that use the gauge so that the gauge can be flush mounted.

These are made out of .090 6061 aluminum and have a natural finish. Gauge not included.


$60.00


$70.00

Categories: CRC Products Tags:

CRC Lug Nut Inserts

November 4th, 2009 admin Comments off

Replace those heavy aftermarket lug nuts and washers with these light weight inserts. Add a set of 12 point 1/2-20 fasteners and you save weight plus they look great.

Categories: CRC Products Tags: